RADVision Scopia XT5000 Series Guia de Instalação descarregar pdf (Página 75)

Note

You can return to the Default Auto settings at any time by pressing and holding down the

Layout key and then pressing the 0 key.

You can configure your monitor so that the user sees two or three video streams on the

monitor(s): local video, remote video, and a data presentation.

•

PIP (Picture In Picture) displays two overlapped images on one monitor, where the remote

image is in full-screen format, and local image is in a smaller, overlapped window.

•

PaP (Picture and Picture) displays two images side-by-side on one monitor, where the

remote image and the local image have the same size, emulating a dual-monitor setup.

•

PoP (Picture out Picture) displays two images side-by-side on one monitor, where the

remote image is larger than the local image.

Procedure

Step 1

Access the general monitor settings as follows:

•

From the endpoint, select Configure > Advanced > I/O connections > Monitor >

General.

•

From the web interface, select Administrator settings > I/O connections > Monitor >

General.

Figure 5-26 Configuring the general monitor settings from the web interface

Step 2

Configure the settings as described in Table 5-10 on page 71.

RADVISION | Installation Guide for SCOPIA XT5000 Series Version 3.1 Initial Configuration | 70

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 112 113

Sem comentários

RADVision Scopia XT5000 Series Guia de Instalação Página 75